100536 - 30 iN. 2-STAgE SNOwbLOwER
ASSEMbLY
15
4. Put the snow discharge chute cable wire form on the snow
discharge support using the washer (4-1) and nut (4-2).
Securely tighten the assembly (Fig. 4) using included tool or
your own 16mm wrench. This will be the guide that channels
all the cables over the engine from the chute area.
4–1
4–2
Figure 4
5. Route the cables through the support rod wire form (5-1) and
cord clamp (5-2) on the lower handle. Additional cable ties
are included to neaten up the cables. Keep loose before first
use and adjust. When comfortable all the cabling is in proper
position, tighten up the cable ties (Fig. 5).
5–1
5–2
Figure 5
Add Engine Oil
wARNiNg
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the snowblower as a result of failing to follow these
instructions will void your warranty.
NOTiCE
The snowblower rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the bearing.
NOTiCE
The recommended oil type for typical use is
0W-30
automotive oil
.
If running snowblower in extreme temperatures, refer to the
following chart for recommended engine oil type.
-20
0
20
40
60
Ambient temperature
Recommended Engine Oil Type
80
100
120
-28.9
°F
°C
-17.8 -6.7 4.4
15.6 26.7 37.8
48.9
10W-30
5W-30 Synthetic
10W-40
5W-30
1. Place the snowblower on a flat, level surface.
2. Remove the oil cap/dipstick (6-1) and wipe it clean (Fig. 6A).
6–1
Figure 6A
3. Insert the oil cap/dipstick into the oil filler neck but do not
screw it in, then remove it to check the oil level (Fig. 6B).
Oil Needed
Oil Fill
Figure 6B
