)NSTALL THE 0ROTECTOR 3YSTEM
)NSTALL THE 3AFETY 2EVERSING 3ENSORS
HARDWARE
Carriage Bolt
1/4"-20 x 1/2"
Wing Nut
1/4"-20
4HE SAFETY REVERSING SENSORS CAN BE ATTACHED TO THE DOOR TRACK THE WALL OR THE FLOOR )F THE DOOR TRACK
WILL NOT SUPPORT THE SENSOR BRACKET A WALL INSTALLATION IS RECOMMENDED #HOOSE ONE OF THE FOLLOWING
INSTALLATIONS
/04)/. ! $//2 42!#+ ).34!,,!4)/.
3LIDE THE CURVED ARMS OF THE SENSOR BRACKET AROUND THE EDGE OF THE DOOR TRACK 3NAP INTO
PLACE SO THAT THE SENSOR BRACKET IS FLUSH AGAINST THE TRACK
3LIDE THE CARRIAGE BOLT INTO THE SLOT ON EACH SENSOR
)NSERT THE BOLT THROUGH THE HOLE IN THE SENSOR BRACKET AND ATTACH WITH THE WING NUT 4HE LENSES
ON BOTH SENSORS SHOULD POINT TOWARD EACH OTHER -AKE SURE THE LENS IS NOT OBSTRUCTED BY THE
SENSOR BRACKET
No more
than 6 inches
(15 cm)
Carriage Bolt
1/4"-20 x 1/2"
Wing Nut
1/4"-20
1
2
3
/04)/. " 7!,,).34!,,!4)/.
)F ADDITIONAL CLEARANCE IS NEEDED AN EXTENSION BRACKET NOT PROVIDED OR WOOD BLOCKS CAN BE USED
-AKE SURE EACH BRACKET HAS THE SAME AMOUNT OF CLEARANCE SO THEY WILL ALIGN CORRECTLY
0OSITION THE SENSOR BRACKET AGAINST THE WALL WITH THE CURVED ARMS FACING THE DOOR -AKE SURE
THERE IS ENOUGH CLEARANCE FOR THE BEAM TO BE UNOBSTRUCTED -ARK HOLES
$RILL INCH PILOT HOLES FOR EACH SENSOR BRACKET AND ATTACH THE SENSOR BRACKETS TO THE WALL
USING LAG SCREWS NOT PROVIDED
3LIDE THE CARRIAGE BOLT INTO THE SLOT ON EACH SENSOR
)NSERT THE BOLT THROUGH THE HOLE IN THE SENSOR BRACKET AND ATTACH WITH THE WING NUT 4HE LENSES
ON BOTH SENSORS SHOULD POINT TOWARD EACH OTHER -AKE SURE THE LENS IS NOT OBSTRUCTED BY THE
SENSOR BRACKET
(Not provided)
No more than
6 inches (15 cm)
1
2
Insid
e
Gar
age
Wall
(Not provided)
Lens
Carriage Bolt
1/4"-20 x 1/2"
Wing Nut
1/4"-20
3
4
