29
Without a properly installed safety reversal system,
persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage
door.
• Safety reversal system MUST be tested every month.
• After ANY adjustments are made, the safety reversal
system MUST be tested. Door MUST reverse on
contact with 1-1/2" high (3.8 cm) object (or 2x4 laid
flat) on the floor.
ADJUSTMENT STEP 3
Test the Safety Reversal System
TEST
•
W
ith the door fully open, place a 1-1/2" (3.8 cm)
board (or a 2x4 laid flat) on the floor, centered
under the garage door.
• Operate the door in the do
w
n direction. The door
must
re
v
erse on striking the obstruction.
ADJUST
• If the door stops on the obstruction, it is not
tra
v
eling far enough in the do
w
n direction.
Complete Adjustment Steps 1 and 2 Programming
the Limits and Forces.
NOTE:
On a sectional door, make sure limit
adjustments do not force the door arm beyond a
straight up and down position. See Figure 3,
page 25.
• Repeat the test.
•
W
hen the door re
v
erses on the 1-1/2" (3.8 cm)
board (or 2x4 laid flat), remo
v
e the obstruction and
run the opener through 3 or 4 complete tra
v
el
cycles to test adjustment.
• If the unit continues to fail the Safety Re
v
erse Test,
call for a trained door systems technician.
IMPORTANT SAFETY CHECK:
Test the Safety Re
v
erse System after:
• Each adjustment of door arm length, limits, or
force controls.
• Any repair to or adjustment of the garage door
(including springs and hard
w
are).
• Any repair to or buckling of the garage floor.
• Any repair to or adjustment of the opener.
ADJUSTMENT STEP 4
Test The Protector System
®
• Press the remote control push button to open the
door.
• Place the opener carton in the path of the door.
• Press the remote control push button to close the
door. The door
w
ill not mo
v
e more than an inch
(2.5 cm), and the opener lights
w
ill flash.
The garage door opener
w
ill not close from a remote
if the indicator light in either sensor is off (alerting
you to the fact that the sensor is misaligned or
obstructed).
If the opener closes the door when the safety
reversin
g
sensor is obstructed (and the sensors
are no more than 6" (15 cm) above the floor), call
for a trained door systems technician.
Safety Reversing Sensor
Safety Reversing Sensor
Without a properly installed safety reversing sensor,
persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage
door.
1-1/2" (3.
8
cm)
b
oard
(or a 2x4 laid flat)
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
