21
DOOR TRACK MOUNT (RIGHT SIDE)
Indicator
Light
Lens
Lip
Sensor
Bracket
Door
Track
FLOOR MOUNT (RIGHT SIDE)
WALL MOUNT (RIGHT SIDE)
Indicator
Light
Sensor
Bracket
Lens
Extension
Bracket
(See Accessories)
Inside
Garage
Wal
l
(Provided with
Extension
Bracket)
(Provided with
Extension Bracket)
Figure 1
Figure 2
Figure 3
Figure 4
WALL MOUNT (RIGHT SIDE)
Attach with
Concrete Anchors
(Not Provided)
Inside
Garage
Wal
l
Sensor
Bracket
Lens
Indicator
Light
Inside
Garage
Wal
l
Indicator
Light
Sensor
Bracket
Lens
Lag Screws
(Not Provided)
Fasten Wood Block to Wall with
Lag Screws (Not Provided)
INSTALLING THE BRACKETS
Be sure power to the opener is disconnected.
Install and align the brackets so the sensors
w
ill face
each other across the garage door,
w
ith the beam no
higher than 6" (15 cm) abo
v
e the floor. They may be
installed in one of three
w
ays, as follo
w
s.
Garage door track installation (preferred):
• Slip the cur
v
ed arms o
v
er the rounded edge of
each door track,
w
ith the cur
v
ed arms facing the
door. Snap into place against the side of the track.
It should lie flush,
w
ith the lip hugging the back
edge of the track, as sho
w
n in Figure 1.
If your door track
w
ill not support the bracket
securely,
w
all installation is recommended.
Wall installation (Figure 2 & 3):
• Place the bracket against the
w
all
w
ith cur
v
ed arms
facing the door. Be sure there is enough clearance
for the sensor beam to be unobstructed.
• If additional depth is needed, an extension bracket
(See Accessories) or
w
ood blocks can be used.
• Use bracket mounting holes as a template to locate
and drill (2) 3/16" diameter pilot holes on the
w
all
at each side of the door, no higher than 6" (15 cm)
abo
v
e the floor.
• Attach brackets to
w
all
w
ith lag scre
w
s
(
N
ot pro
v
ided).
• If using extension brackets or
w
ood blocks, adjust
right and left assemblies to the same distance out
from the mounting surface. Make sure all door
hard
w
are obstructions are cleared.
Floor installation (Figure 4):
• Use
w
ood blocks or extension brackets (See
Accessories) to ele
v
ate sensor brackets so the
lenses
w
ill be no higher than 6" (15 cm) abo
v
e the
floor.
• Carefully measure and place right and left
assemblies at the same distance out from the
w
all.
Be sure all door hard
w
are obstructions are cleared.
• Fasten to the floor
w
ith concrete anchors as
sho
w
n.
Wing N
u
t
1/4"-20
Staples
Carriage Bolt
1/4"-20x1/2"
HARDWARE SHOWN ACTUAL SIZE
