27
ADJUSTMENT STEP 1
Program the Travel Limits
Travel limits regulate the points at which the
door will stop when moving up or down. Follow
the steps below to set the limits.
To program the travel limits:
1. Press and hold the black button until the yello
w
indicator light starts flashing slo
w
ly then release.
2. Push and hold the black button until the door
reaches the desired UP (open) position
(Figure 2)
.
Adjust the position of the door by using the black
and purple buttons. Black mo
v
es the door UP
(open) and purple mo
v
es the door DO
WN
(close).
Check to be sure the door opens high enough for
your
v
ehicle.
NOTE:
Refer to previous page for correct door
position for one-piece door.
3. Push the remote control or door control
(Figure 3)
.
This sets the UP (open) limit and begins closing
the door. Immediately press either the black or
purple button; the door
w
ill stop.
Adjust the desired DO
WN
(close) limit position
using the black and purple buttons
(Figure 4)
.
Check to be sure the door is fully closed
w
ithout
applying excessi
v
e pressure on the rail (rail should
not bo
w
up
w
ards and the belt should not sag or
droop belo
w
the rail). Push the remote control or
door control
(Figure 3)
. This sets the DO
WN
(close) limit and begins opening the door.
Without a properly installed safety reversal system,
persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage
door.
• Incorrect adjustment of garage door travel limits will
interfere with proper operation of safety reversal
system.
• After ANY adjustments are made, the safety reversal
system MUST be tested. Door MUST reverse on
contact with 1-1/2" high (3.8 cm) object (or 2x4 laid
flat) on floor.
Purple
Button
Black
B
u
tton
Antenna
Indicator
Light
WARNING
WARNING
WARNING
To prevent damage to vehicles, be sure fully open door
provides adequate clearance.
WARNING
CAUTION
WARNING
WARNING
Fi
g
ure 1
4. Open and close the door
w
ith the remote control or
door control 2 or 3 times.
If the door stops in both the desired UP (open) and
DO
WN
(close) positions, proceed to
Adjustment
Step 2, Setting the Force, followed by Adjustment
Step 3, Test the Safety Reversal System.
BLACK
PURPLE
P
u
sh and hold
u
ntil the door
is at desired
UP
position
Fi
g
ure 2
Fi
g
ure 3
BLACK
PURPLE
P
u
sh either
bu
tton to stop
door at desired
DOWN
position
Fi
g
ure 4
LOCK
LIGHT
or
