Intended use
The device is intended for the opening and closing of garage doors
(please refer to section 6 “Door Types”).
Any improper use of the drive could increase the risk of accidents.
The manufacturer assumes no liability for such usage.
Scope of supply
Please check the supplied parts for completeness before starting the instal-
lation. Note: The numbering only applies to the corresponding section.
Product overview
This figure always offers you a complete overview of the ready-
assembled system during the step by step installation of the system.
Parts overview (Drivehead):
1. Drive head
1x
2. Remote control
2x
3. Support bracket
1x
4. Hardwarebag
1x
Parts overview (Rail):
5. Header bracket
1x
6. Door bracket
1x
7. Adapter for gear wheel
1x
8. Curved door arm
1x
9. Support bracket
2x
10. Hanging bracket
2x
11. Rail
1x
Note: Illustration shows basic content.
Depending on the exact model or combi-
nation purchased contents are different.
Hardwarebag:
1. Truss head screw
6 x 80 mm
1x
2. Lock nut M6
1x
3. Hexagonal head screw
4x
4. Nut M6
4x
5. Bolt
1x
6. Safety cotter pin
1x
7. Screw ST6 x 50 mm
4x
8. Screw ST6,3 x 18 mm
2x (4x)
9. Plug
4x
1. Header bracket
2. Belt
3. Rail
4. Carriage
5. Connecting piece
6. Mounting bracket
7. Support bracket
8. Power cable
9. Drive head
10. Release
11. Straight door arm
12. Curved door arm
13. Door bracket
2
3
Before you begin
IMPORTANT NOTE
If your garage does not have a side entrance, an external emergency
release should be installed. This allows for manual operation of the garage
door from the outside during power failure.
Door Types
4
5
6
en 02/13
Preparation
First, check whether your door is balanced and in equilibrium.
Open your door about halfway and let it go.
The door can now hardly change its position
independently,
but must remain in this position held by the spring force alone.
1. The rail of the garage door MUST be connected securely and firmly to
the supporting wall or ceiling above the garage door.
2. Additional brackets and mounting rails (not included in the supply) might
be required, if the your garage ceiling has a cladding, boards or similar.
3. If your garage does not have a separate side entrance, an external
emergency release (refer to section 34 “Optional Accessories”) must be
installed.
Tools required
6.1
7
Tool list:
Ladder
Marking pen
Pliers
Drilling machine
Hammer
Ratchet 10 mm / 13 mm
Hacksaw
Different drill bits for concrete
and(or wood (8, 6, 5, 4.5 mm)
Box wrench
Water level
Screwdriver
Measuring tape
A. One-Piece Door with Horizontal Track Only.
B. One-Piece Door with Horizontal and Vertical Track – Special door arm
(E, The Chamberlain Arm™) and the Protector System™
required. See your dealer.
C. Sectional Door with Curved Track – See 20B – connect door arm.
D. Canopy door – Special door arm (E, The Chamberlain Arm™) and the
Protector System™ required. See your dealer.
E. The Chamberlain Arm™ for use on door types B and D.
