Start by Reading These Important Safety Instructions
WARNING!
- The door should be balanced. Unmoving or stuck doors must be
repaired. In an unbalanced state, garage doors, door springs, cables,
discs, brackets and rails are under extreme tension, which can lead to
serious injury. Do not attempt to loosen, move or realign the door, but
contact service centre or a door professional.
- During the installation or maintenance of a door opener, no jewellery,
watches or loose clothing should be worn.
- To avoid serious personal injury due to entanglement, remove all cables
and chains connected to the door before installing the door opener.
- During installation and electrical connection, the local building and electri-
cal regulations must be observed.
This device complies with Protection Class 2 and does not require
grounding.
- To avoid damage to very light doors (such as fibre glass, aluminium or
steel doors), an appropriate reinforcement should be added.
To do so, contact the door manufacturer.
- The automatic safety reverse system should undergo a test. Upon contact
with a 50 mm high barrier on the ground, the garage door MUST return.
Failure to properly adjust the door opener can result in serious personal
injury from a closing garage door. Repeat test once a month and make any
needed changes.
- This system must not be installed in damp or wet areas.
- During operation, the gate should not under any circumstances obstruct
public passageways.
- To remind all operators of the safe operation, in addition to the illuminat-
ed wall switch
a warning sign to protect children
should be affixed.
The
warning signs about the risk of trapping should be placed in clearly
visible
spots.
- Children should be supervised to ensure that they do not play with the
device.
- This device is not intended for use by persons (including children) with
restricted physical, sensory or mental abilities or lack of experience
and/or
knowledge, unless they are supervised by a person responsible
for their
safety or have received instruction in how to use the device.
- All barriers / locks are deactivated to avoid damage to the door.
- If necessary, installed control equipment MUST
be mounted within sight
of the door and out of reach of children. Children should not be allowed
to
operate the buttons or remote controls. Misuse of the door opener can
result in serious injury.
- The door opener should ONLY
be used if the operator can see the entire
door area and is assured that it is free of obstacles and the door opener is
set correctly. No one may pass through the door while it is moving.
Children must not be allowed to play in the vicinity of the door.
- Use the manual release only for the separation of the carriage from the
drive and – if possible –
ONLY
with the door closed.
Do not use the red handle to push the door up or pull it down.
- Before performing any repairs or removing covers, the door opener
should be separated from the electric power supply.
- This product has a transformer with a special power cord. In case of
damage this MUST
be replaced with an original transformer by a
qualified
technician.
- Operation of the emergency release can lead to uncontrolled movements
of the door, if springs are weak or broken or if the door is unbalanced.
- Mount the release handle of the emergency release at a heig
ht less than
1.80 m.
Save these instructions.
CAUTION Personal injury or property damage
CAUTION Danger due to electric current or voltage
General safety guidelines
Before you begin the installation:
Please read the operating instructions and especially the precautions. Keep the manual for future reference and pass it on to a possible subsequent owner.
The following symbols are placed in front of instructions to avoid personal injury or property damage. Read these instructions carefully.
Important safety information
The automated door opening system has been as a matter of course tested and designed for safe operation, but safety can be assured only if the safety
instructions listed below are strictly adhered to during installation and operation
en 01/13
- The installer (specialist) must carefully read and understand these instruc-
tions before starting any work. Before first use and at least annually a
specialist must inspect powered windows, doors and gates regarding their
safe condition.
Specialist is, who on the basis of their technical training and experience,
has sufficient knowledge in the field of powered windows, doors and gates
and moreover is familiar with relevant state occupational safety regulations
and generally accepted rules of technology in such an extent that he is
also able to assess the safe working condition of powered windows, doors
and gates.
