![background image](http://html1.mh-extra.com/html/ch-hanson/norse-9681115/norse-9681115_operating-instructions-and-parts-manual_2585539007.webp)
INSTALLATION (CONTINUED)
Adjusting Disc Table Angle
Ensure sander is disconnected from the power supply prior to
commencing work.
1. To check the trueness of the 90º angle of the disc sanding
table, place a square or other measuring device on the table
with the other end against the sanding disc. See Figure 8.
2. Loosen the disc table adjustment handle, and adjust table
angle to 90º.
3. Re-tighten the disc table adjustment handle.
4. Adjust the angle scale pointer to 0°.
5. To adjust the disc table to another angle, loosen the disc table
adjustment handle.
6. Set the table at the desired angle using the angle scale pointer.
7. Re-tighten the disc table adjustment handle.
To avoid jamming the work piece or
fingers between the table and sanding
surface, the table edge should be set to a maximum of 1/16
inches away from sanding surface. See Figure 9.
Adjusting Belt Assembly Position
The sanding belt frame can be easily adjusted from a horizontal
position to a vertical position, or any other position to assist your
sanding operation.
1. Loosen the hex screw that pulls the split casting together. This
allow the sanding belt frame to be moved to the work angle
desired. See Figure 10.
2. Once the sanding belt frame is at the desired work angle, re-
tighten the hex screw to secure it in place.
3. In the horizontal position, there are two vertical padded hex
screws that support the sanding belt frame. These should be
checked and adjusted, if necessary, to make sure that they both
touch the sanding belt frame supports. These screws will help
relieve pressure on the casting during work. See Figure 11.
7
NORSE Operating Manual & Parts List 9681115
G
ET
TIN
G
S
TA
R
TE
D
SA
FE
TY
/ S
PE
CIF
IC
AT
IO
NS
AS
SE
M
BL
Y /
IN
ST
AL
LA
TIO
N
O
PE
R
AT
IO
N
TR
O
U
B
LE
SH
O
O
TIN
G
M
AIN
TE
NA
NC
E /
RE
PA
IR
Figure 8 - Check disc trueness.
Figure 9
1/16˝
Figure 10
Figure 11
Sanding belt
frame supports.
Hex Screw
9681115_oipm_En012_9643069.01 0518 05/22/18 Page 7