![background image](http://html1.mh-extra.com/html/ch-hanson/norse-9681115/norse-9681115_operating-instructions-and-parts-manual_2585539015.webp)
15
NORSE Operating Manual & Parts List 9681115
G
ET
TIN
G
S
TA
R
TE
D
SA
FE
TY
/ S
PE
CIF
IC
AT
IO
NS
AS
SE
M
BL
Y /
IN
ST
AL
LA
TIO
N
O
PE
R
AT
IO
N
TR
O
U
B
LE
SH
O
O
TIN
G
M
AIN
TE
NA
NC
E /
RE
PA
IR
TROUBLESHOOTING GUIDE
Symptom
Possible Cause(s)
Corrective Action
Motor will not start
Motor will not start; fuses blown
or circuit breakers tripped
Motor fails to develop full power
(power output of motor de-
creases rapidly with decrease in
voltage at motor terminals)
Motor overheats
Motor stalls
(resulting in blown fuses or
tripped circuit breakers)
Machine slows down while
operating
Abrasive belt runs off top wheel
1. Blown line fuse or tripped circuit
breaker
2. Low line voltage
3. Defective switch
4. Defective, blown capacitor
1. Overloading due to binding
2. Defective plug
3. Defective cord
4. Defective switch
5. Faulty internal wiring
1. Power line overloaded with lights,
appliances and other motors
2. Undersized wires or circuits too long
3. General overloading of power
company’s facilities
Motor overloaded
1. Short circuit in motor or loose
connections
2. Low voltage
3. Incorrect fuses or circuit breakers in
power line
4. Motor overloaded
1. Applying too much pressure to
workpiece
2. V-belt slipping
Not tracking properly
1. If fuse is blown, replace with fuse of proper size.
If breaker tripped, reset it
2. Check power supply for voltage and correct as
needed
3. Replace switch
4. Replace capacitor
1. Clean around wheels and shaft and/or replace
bearings
2. Replace plug
3. Replace cord
4. Replace switch
5. Contact authorized NORSE Service Center
1. Reduce load on power line
2. Increase wire sizes, or reduce length of wiring
3. Request a voltage check from power company
Reduce load on motor
1. Inspect connections in motor for loose or
shorted terminals or worn insulation on lead
wires
2. Correct the low line voltage conditions
3. Install correct fuses or circuit breakers
4. Reduce load on motor
1. Ease up on pressure
2. Increase V-belt tension
See operation section “Adjusting Sanding Belt
Tracking”, page 8.
9681115_oipm_En012_9643069.01 0518 05/22/18 Page 15