ASSEMBLY
Do not attempt assembly if parts are
missing. Use this manual to order repair
parts.
the sander must NOT be plugged in and
the power switch must be in the "OFF"
position until assembly is complete.
Installing the Foot Pads
Four rubber foot pads are supplied to protect your work surface,
and to reduce any vibration that may develop when the sander is
operating.
1. Tilt the sander up and slide the feet onto each of the four
corners of the sander. No hardware is needed. See Figure 1.
Installing the Sanding Belt Fences
The sander includes two fences for use with the sanding belt. The
small fence/platen attaches directly to the sanding belt frame, and
is used for supporting small items being sanded.
The larger fence/platen attaches onto the small fence. It gives a
larger support surface for sanding large work pieces.
NOTE: These parts may be pre-assembled at the time of delivery.
If not, follow the following parts assembly:
1. Install the small fence onto the sanding belt frame with the four
hex screws and washers. See Figure 2.
2. Insert two star-head screws through the countersunk holes in
the large fence and install the knobs on their threaded ends.
(Washers shown in Figure 3 are optional, not included with
sander).
3. Slide the large fence’s two screws with knobs over the two
slots in the small fence and fasten in place. Pending on the
material being sanded, the large fence can easily be removed
by just loosening the two knobs and sliding it off the small
fence. See Figure 3.
Installing the Disc Table
Refer to figures 4 and 5.
The larger worktable is used with the sanding disc. It should be
used to support workpieces in all sanding operations except inside
curve applications.
1. Locate worktable handles and washers in parts bag.
2. Place the worktable onto the sander frame, aligning the semi-
circle slot with the threaded hole.
3. Place a washer on threaded shaft of each worktable handle,
insert through semi-circular slot, and tighten into threaded hole.
Repeat on other side of table.
4. Adjust worktable to level or any angle between 0° and 45° for
sanding.
NOTE: Always check to make sure the handles are tight before
beginning any sanding operation.
5
NORSE Operating Manual & Parts List 9681115
G
ET
TIN
G
S
TA
R
TE
D
SA
FE
TY
/ S
PE
CIF
IC
AT
IO
NS
AS
SE
M
BL
Y /
IN
ST
AL
LA
TIO
N
O
PE
R
AT
IO
N
TR
O
U
B
LE
SH
O
O
TIN
G
M
AIN
TE
NA
NC
E /
RE
PA
IR
Figure 2 - Install small fence.
Figure 3 - Install fence knobs.
Figure 4
Work Table
Washers
Lock Handle
Figure 1 - Install foot pads.
9681115_oipm_En012_9643069.01 0518 05/22/18 Page 5
