CGEO-PR-VW Vibrating Wire Portable Readout
CGEO INTERNATIONAL LIMITED
Installation Manual
Forward
This instruction manual, describes the technique required for the installation of centre hole load cells.
It is important that the materials and equipment covered by this manual should be installed by
competent and suitably qualified personnel. They must READ AND UNDERSTAND the procedures
outlined in this manual before attempting installation of the equipment on site.
CGEO INTERNATIONAL LIMITED will not accept for repair under guarantee, instruments/materials
neglected or mishandled in any way.
The techniques described are intended to serve as a general guide and may vary to suit particular site
conditions.
Section 1 : Introduction
The CGEO Vibrating Wire Readout has been designed for the measurement of vibrating wire sensors
as manufactured by CGEO INTERNATIONAL LIMITED and of some other manufacturers.
1.01
Main Features:
1. The complete sealed and portable construction, water-resistant panel and a large backlit
LCD allows the readout box work under any weather conditions.
2. Can be operated by hand or automatically.
3. Shortcut keys as allow improve working efficiency.
4. The data storage has the capacity to store over 1900 measurements.
5. By using the RS-232C communication port the readout box can be programmed measuring
parameters, data communicating etc.
6. High accuracy and stability.
7. Automatically turn-off if unused for fifteen minutes.
8. The powerful lithium battery ensures long periods of use.
1.02
Front Panel:
Summary of Contents for CGEO-PR-VW
Page 22: ......
