6
Jr.
Sodcutter
9b. NOTE: in this step, it is necessary to do three
things at one time.
1. The clevis assembly must be positioned just
to the right side of the belt, near the belt idler
arm.
Figure 3.
FIGURE 3
1. Brake Band
2. 1/4-20 Screw
3. Clevis
2. The brake band is positioned over the belt in
the large pulley groove. Figure 4.
FIGURE 4
1. "L" Bracket
3. The handle support is positioned, in the
bottom slot behind wheel, Figure 2, and then the
upper two bolts are attached with the "L" bracket
in the left hole. Figure 4. BE SURE the slotted
side of the "L" brackets is facing toward the large
pulley.
10. Connect the flat end of the clevis assembly to the
idler arm as shown in Figure 3. The hardware
needed is on the clevis assembly. This should
pivot freely after it is tightened.
11. Route convoluted tubing from the control panel to
the front of the engine and attach at three points
with clips shown in Fiugre 5 and 6. Route wiring
and cable on the inside of the bracket. Route
convoluted tubing next to the hour meter wire
ty-rap together below the clip on the convoluted
tubing. Figure 7.
FIGURE 5
1. Tubing Clips
FIGURE 6
1. Tubing Clip
SET-UP
Summary of Contents for Ryan 544946A
