19
Jr.
Sodcutter
BLADE SPROCKET SHAFT
1. Follow steps 1 thru 6 in pulley shaft section.
2. Loosen clamp screw on left pitman arm
C
and
remove from shaft.
3. Loosen clamp screw in eccentric assembly
D
and
remove.
4. Remove two (2) top screws securing the other
side arm assembly. Side arm, shaft and pitman
arm, are now removable by pulling side arm out.
5. Remove eccentric and both bearing cages
E
. Put
a pan under rear portion of case to catch oil from
case cavity.
6. Push shaft to left of case, lift right end of shaft out
of case with bearings and sprocket intact.
7. To remove sprocket, press bearing from shaft,
and slide sprocket off.
NOTE:
End play on shaft must not exceed .005
(.127 mm) clearance and should rotate freely when
bearing cages are tightened.
8. Assemble in reverse procedure. After blade
shifter assembly is installed, adjust dog clutch
to provide .015" (0.39 mm) clearance between
clutch faces, as shown.
9. Apply 3M Scotch Grip 847 adhesive or equivalent
to gear case cover before installation.
SERVICE
.015
(0.39 mm)
Summary of Contents for Ryan 544946A
