17
Jr.
Sodcutter
SERVICE
ADJUSTING DEPTH OF CUT
1. Make a trial run in turf. Set depth to cut
approximately 3/4" of soil.
2. Loosen depth gauge handle. Adjust depth gauge
G
to contact bottom on depth control lever
D
.
3. Loosen depth control locking lever
E
and lower
depth control
D
until it rests on depth gauge
G
.
4. Tighten depth control locking lever
E
.
NOTE:
Numbers on depth gauge do not necessarily
represent thickness of sod being cut.
ADJUSTING OPERATOR PRESENCE CONTROL
1. To adjust operator presence cable, pull clutch
control handle
A
rearward as far as possible.
2. Press operator presence handle (right handlebar)
down as far as possible.
3. Adjust cable until the pivot arm
C
contacts the
arm extending from the operator presence switch
B
.
4. Tighten cable clamp to secure cable. Check for
proper operation.
Summary of Contents for Ryan 544946A
