Ceyear 1465 Series, Programming Manual

Page: 34 / 143

2 Remote Control
2.2 Remote interface and its configuration
27
2.2 Remote interface and its configuration

LAN ...................................................................................................................... 27

GPIB .................................................................................................................... 28
2.2.1 LAN
The programmed control system of LAN (Local Area Network) uses SICL-LAN to control the 1465 series
signal generator.
Use of USB main control port connector on front panel
The Type-A connector on the front panel is for USB master control port. In the 1465 series signal
generator, this port is used to be connected to the flash disk of USB 2.0 interface to realize the
instrument‘s resident software upgrade, and can also be connected to the USB keyboard and mouse to
control the signal generator. It is not possible to remotely control the instrument via this port.
． ．． ．．． ．．．． ． ． ． ． ．． ．． ．．． ． ． ． ．．．． ． ． ． ．． ．．． ．． ． ． ．．．． ．． ． ．． ． ． ．．． ． ． ．

Connection Establishment .................................................................................. 27

Interface Configuration ........................................................................................ 27
2.2.1.1 Connection
Connect the 1465 series signal generator and the external controller (computer) to LAN with network
cable, as shown in Fig. 2.6:
IP address
IP address
LAN
Fig. 2.6 LAN Interface Connection
2.2.1.2 Interface configuration
When the signal generator is remotely controlled via LAN, the physical network connection shall be
guaranteed to be smooth. Because DHCP, domain name access and wide area network connection are
not supported, the network program control setting of the signal generator is relatively simple.
Press
【
System
】
→[LAN Interface] to enter the interface shown in Fig. 2.7 and set the ―IP address‖,
―Subnet mask‖ and ―Default gateway‖ to the subnet of main controller.
CAUTION