Ceyear 1465 Series, Programming Manual

Page: 113 / 143

3 SCPI
3.3 Instrument subsystem command
106
Parameter:
<Mode> Discrete data. The mode in which sequence file responses to trigger signal when ARB is in
Wave Segment mode,
The values are as follows:
SINGle | 0: Single waveform segment trigger,
CONTinuous | 1: Continue waveform segment, trigger.
Example: [:SOURce]:RADio:ARB:TRIGger:TYPE:SADVance:TYPE SING
When ARB is in Wave Segment mode, set the mode in which sequence file responds to trigger
signal to Single.
Reset status: SING
Key Entry:
【
Arb
】 —>[Trigger]—>[Trig Mode]—>[Wave Segment >>]
[:SOURce]:RADio:ARB:TRIGger:TYPE:GATE:ACTive <Mode>
Function: This command sets the mode in which sequence file responds to trigger signal when
ARB is in Gate mode. There are two modes for selection, Low/Hight. For setting Trig
Mode, see the command ―
:RADio:ARB:TRIGger:TYPE
‖.
Setting format: [:SOURce]:RADio:ARB:TRIGger:TYPE:GATE:ACTive
LOW|HIGH
Query format: [:SOURce]:RADio:ARB:TRIGger:TYPE:GATE:ACTive?
Parameter:
<Mode> Discrete data. The mode in which sequence file responds to trigger signal when ARB is in
Gate mode,
The values are as follows:
LOW | 0: Low,
HIGH | 1: Hight.
Example: [:SOURce]:RADio:ARB:TRIGger:TYPE:GATE:ACTive LOW
When ARB is in Gate mode, set the mode in which sequence file responds to trigger signal to Low.
Reset status: LOW
Key Entry:
【
Arb
】 —>[Trigger]—>[Trig Mode>>]—>[Gate>>]
[:SOURce]:RADio:ARB:TRIGger:SOURce <Mode>
Function: This command sets ARB Trig Source.
Setting format: [:SOURce]:RADio:ARB:TRIGger:SOURce KEY|BUS|EXT|INT
Query format: [:SOURce]:RADio:ARB:TRIGger:SOURc e?
Parameter:
<Mode> Discrete data. ARB Trig Source,
The values are as follows:
KEY: Trigger key,
BUS: Bus,
EXT: External,
INT: Internal.
Example: [:SOURce]:RADio:ARB:TRIGger:SOURce BUS