Ceyear 1465 Series, Programming Manual

Page: 110 / 143

3 SCPI
3.3 Instrument subsystem command
103
value will be valid only when Clock Type is set to User Defined. For setting Clock Type,
see the command ―
:RADio:ARB:SEQuence:CLOCk
‖.
Setting format: [:SOURce]:RADio:ARB:SCLock:RATE <val><freq unit>
Query format: [:SOURce]:RADio:ARB:SCLock:RATE?
Parameter:
<ClockRate> I/Q signal Q offset.
Range: 100MHz[0.01MHz
，
250MHz].
Example: [:SOURce]:RADio:ARB:SCLock:RATE 50MHz ARB Clock Freq is 50 MHz.
Reset status: 100MHz
Key Entry:
【
Arb
】 —>[Base Config] —>[Clock Freq]
[:SOURce]:RADio:ARB:TRIGger:TYPE <Mode>
Function: This command is used for setting the trigger modes for control of waveform play, which
include CONTinuous, SINGle, GATE and SADVance. For single trigger function, the
system may receive effective trigger event only after the play of current code pattern
sequence has been accomplished. In addition, multiple status can be set at
CONTinuous, SINGle, GATE and SADVance modes. See the command
―
:RADio:ARB:TRIGger:TYPE:CONTinuous
‖,
―
:RADio:ARB:TRIGger:TYPE:SINGle
‖,
―
:RADio:ARB:TRIGger:TYPE:SADVance:TYPE
‖,
―
:RADio:ARB:TRIGger:TYPE:GATE:ACTive
‖.
Setting format: [:SOURce]:RADio:ARB:TRIGger:TYPE CONTinuous
|SINGle|SADVance|GATE
Query format: [:SOURce]:RADio:ARB:TRIGger:TYPE?
Parameter:
<Mode> Discrete data. At Arb mode, options for trigger mode for control of waveform play are:
CONTinuous | 0: When Trig Mode is set to Continue, the waveform
sequence will be played repeatedly after the instrument has
received effective trigger event;
SINGle | 1: When Trig Mode is set to Single, the waveform sequence
will be played only once after the instrument has received
effective trigger event;
SADVance | 2: When Trig Mode is set to Wave Segment, one waveform
segment will be played each time the instrument receives an
effective trigger event;
GATE | 3: When Trig Mode is set to Gate, the waveform sequence will
be played continuously during the valid time of the gate signal.
Example: [:SOURce]:RADio:ARB:TRIGger:TYPE SING Trig Mode is set to Single.
Reset status: CONT
Key Entry:
【
Arb
】 —>[Trigger]—>[Trig Mode]