CETONI Nemesys S Hardware Manual
19
(2)
Separating the module from the system is done in a slightly different way than described in the system
manual, as the CETONI Nemesys S has a separating mechanism. To separate, press the button
1
on
the front of the module firmly. This releases the plug connection to the previous module. Then pull
the other end of the module off the system by pulling the centering pin
2
. You can now remove the
individual module and reconnect the bus terminating plug (terminator) to the last module of the
remaining system.
5.2
Configuration Contiflow Valve
The CETONI Nemesys S is supplied with a Contiflow Valve. The installation on the device is described in
section 5.10, the electrical connection in section 5.7.
If you have created a configuration with your CETONI Nemesys S
in QmixElements, you must assign the Contiflow Valve you have
in hand to it.
To do this, right-click on the pump panel of the
CETONI Nemesys S and select the item
Configure external valves
.
Then select the Contiflow Valve from the list.
For more detailed information, please refer to the corresponding
software manual.
1
2
