SmaRT BU-x18XF and BU-xH18XF
U069.3.3
8
5.0
Associate Mode
Communication between the SmaRT BU-x18XF and SmaRT remote control units is established
while the system is at the factory before it is shipped. The process can also be applied in the
field when necessary
—when a remote is replaced or added, for example. Access to and the
exact button or switch sequencing used while in Associate mode varies depending on the type of
SmaRT remote control unit the base unit is to communicate with. Please reference the
appropriate SmaRT remote control manual or Cervis, Inc. Engineering Spec Sheet for complete
Associate Mode details.
Caution!
Prevent inadvertent machine movement while establishing the
communication link between SmaRT base units and remote
control units. Always disconnect power from the base unit before
attempting to enter Associate.
Associate Example
The following example shows the steps taken to associate a standard SmaRT PTO-x06 six-
button handheld remote control unit to a SmaRT BU-x18XF base unit.
1. Disconnect power from the base unit, and turn OFF the handheld remote control
unit.
2. Stand near the base unit in unobstructed, clear line-of-sight with the remote
control unit in hand.
3. Simultaneously press and hold the Associate (B1) and Dissociate (B2) buttons.
The RX and ER LEDs light.
4. Continue to hold both buttons until the TX and RX LEDs light steady.
5. When the TX and RX LEDs light, release B1 and B2. The ER and BA LEDs light.
Note: If the next button press is not immediately performed (approximately 2 sec.), all
LEDs flash, and the Associate procedure is aborted. Restart the process to establish the
communication link.
6. Immediately press and hold the Associate button (B1). All LEDs light.
7. The TX LED begins to slowly blink. Continue to hold B1.
8. Apply power to the base unit.
The remote control unit and base unit begin to establish a communication link while the
Associate button is held. Once the process is complete, all LEDs light briefly and then go
out.
9. Release the Associate button.
The TX and RX LEDs flash, indicating that the remote control unit is sending and
receiving messages. The SmaRT System is ready for use.
Figure 5. Remote Control Unit to BU-x18XF/BU-xH18XF Associate Example
Associate (B1)
Dissociate (B2)
