SmaRT 902 Remote Control System
U007.0-SmaRT902_system-R
8
4.0 Using the SmaRT PTO-902 Handheld Remote
The front panel of the SmaRT PTO-902 Handheld Remote has two (2) push-to-operate
buttons and three (3) diagnostic LEDs. Each of the two buttons have dual functions as
described in Figure 9.
Figure 9. PTO-902 Front Panel Buttons and Diagnostic LEDs
To operate the system:
1. Communication between the handheld and base unit must be established
using the Association Procedure (1.4.1).
2. You must be line of sight of the base unit while holding the handheld,
within 300 ft. (100m) of the unit.
3. Each button is push-to-operate (PTO). Each is dedicated to its assigned
(or hardwired) output driven by the base unit. The output is only controlled
when the button is pressed and held.
Push-to-operate base unit
Output 1,
or
Associate to base unit
Push-to-operate base unit
Output 2,
or
Disassociate from base unit
Controlled device ID
(area can be written on
with pen or marker)
TX – Green flashing when
transmitting
RX – Red flashing when
receiving
LINK– Yellow while linking
