34
5.4.5 The control menu
By pressing
on the menu of “Control”, the display will enter the next
control menu tree.
1)
Buzzer mute -
the buzzer will stop beeping
2)
Start battery test - will start a quick battery test
3)
Load segments - allows control of the two load segments when UPS is
in output mode.
4)
Clear EPO status - when EPO status is enabled the UPS output will not
support the output load. To recover to normal status (depending on
EPO Configuration) first EPO connector should be closed, then enter
“clear EPO status”, the UPS will then stop alarming and recover to
bypass or standby mode. The UPS then needs to be turned on by
manual operation.
5)
Reset fault status – if a fault is detected the UPS will enter Fault mode
and generate an alarm. To return to normal, enter this menu to reset
the error. The UPS will then stop alarming and recover to bypass or
standby mode. The cause of the fault should be checked and cleared
before the UPS is turned on again by manual operation.
6)
Clear event log - To clear all events, alarms and faults that have been
recorded.
7)
Restore factory settings – returns all settings back to factory default.
This can only be done in bypass or standby mode.
Summary of Contents for C400R-010-B
Page 7: ...3 ...
