Radikal G30 v.2
Page 5
HEAD ASSEMBLY (FLYBAR HEAD)
BAG 1
1
2
3
4
6
5
7
8
9
10
CNBB0730
CNBB0840
HI3167G
CNLR1017 L=6.5MM
CNM3x8BHCS
CNM3x14BHCS
M3X15CS
No.
Description
Qty
1
2
3
4
5
Part #
6
7
8
9
10
NX Rotor Head Yoke(
主旋翼中心座
)
Seesaw Tie Bar Set(
平衡杆控制臂
)
2
2
2
2
CNBB0730
CNBB0840
CNM3X14BHCS
HW6205
2
2
1
CNM3X15CS
2
Seesaw Offset Plates(
平衡杆固定片
)
3x7x3 Ball Bearing(
轴承
)
4x8x3 Ball Bearing(
轴承
)
(
铁套
)
M3x14 Button Head Cap Screws(
伞头螺丝
)
M3x15 Cap Screws(
杯头螺丝
)
2
CNM3X8BHCS
M3x8 Button Head Cap Screws(
伞头螺丝
)
2
CNLR1017
M3 Ball Link(M3
球头螺丝
)
CN2511B
CN2511C
CN2511C
Apply Red threadlock to the outer race of one 4x8x3 ball bearing and install the
bearing into the bearing cup of the offset plate. Apply Red threadlock to the outer
race of one 3x7x3 bearing and insert it into the seesaw tie bar. Attach the seesaw
tiebar and threadlock the threaded ball and M3x8 button head screw. Attach the
completed end to the headblock making sure you have the seesaw tie bar spacer.
Attach using the completed end using an M3x14 button head screw. Complete
the other end around the headblock. Install the M3x15 cap screw however do
not tighten it as you will be doing this in the following steps once you are ready to
install the head onto the mainshaft.
3x5x3 Spacers
CA
Do not open all the bags prior to starting assembly. Open the bags step by step as you go through the instruction manual. The
components are bagged to make assembly easier. The next few pages will pertain to the assembly of the head. Please follow
the instructions based on the head type you own. Make sure to apply threadlock to any screws going into metal.
