Radikal G30 v.2
Page 33
1
3
2
4
Button Head Cap Screw(
圆头内六角螺丝
)M3x8
CNM3x8BHCS
Aluminum Post(
铝柱
)
HW6202BS
1
1
2
2
No.
Description
Qty
Part #
3
2
4
8
CNM3X25CS
杯头螺丝
Aluminum Post(
铝柱
)
HI6031S
CNM3x25CS
CNM3x8BHCS
Install the tail assembly onto the main frames by using threadlock on the
eight M3x8 button head cap screws. Make sure to install two screws oppo-
site of each other on either side and tighten down making sure the transmis-
sion gear is properly meshed with the tail drive gear. If you are unsure about
proper gear mesh, use a strip of paper slightly taller than the tail drive gear
and pass it between the gears as you spin the tail drive gear. As the paper
passes through from one side of the frames to the other, a nice zig-zagged
pattern should develop. If it is a very faint zig-zag pattern or no pattern ap-
pears, the gear mesh is too loose. If the paper comes through crushed, the
gear mesh is too tight. After the tail assembly is installed on the main frame,
install the tail boom braces using the two M3x25 cap screws and boom
support posts making sure to apply medium threadlock.
For plastic gears, it is best to use a lubricant like
Moly-Kote (Part#: CN2024MK). This will ensure a
much smoother running drivetrain and prolong the
life of the plastic gears. Moly-Kote can also be used
on the metal gears as well.
ATTACHING TAILBOOM
M3x25 Cap Screws(
)
