Page 13
CL
Now that you know the probe works and is triggering properly along with a probing cycle we need to make sure the probe
stylus tip is concentric with the spindle and then the probe will be ready to use!
Probe Alignment
: Center the Ball of the stylus so that it is concentric with the spindle
Using an indicator and the three run out adjustment screws on the body of the probe we will adjust the concentricity of
stylus ball to be concentric with the spindle. This adjustment will place the center of the stylus ball in center of the spindle
axis (stylus tip run-out)
Touch Probe Alignment
