Page 10
STEP 3: Finish tightening the stylus by inserting the stylus wrench in the stylus wrench hole and slowly tighten. Snug
the stylus until the probe begins to deflect and when you feel a mild but firm stop has been reached stop applying torque,
the stylus is now completely tight. Applying too much torque can damage the probe or stylus.
KP-3 Stylus installation
Stylus Removal: If the stylus must be removed insert a pin in the stylus wrench hole and slowly loosen. The stylus mount
boss will turn with the stylus and begin to retract into the probe then firmly stop. When the firm stop has been reached
apply a small amount of additional torque to break the threads free. If excessive torque is required grasp the stylus mount
boss with smooth jaw pliers to prevent damage to the probe. If the stylus was installed correctly it will not require exces
-
sive force to remove it.
