Page 6
SKU 97816
For technical questions, please call 1-800-444-3353.
Avoid unintentional starting. Prepare
5.
to begin work before turning on the
tool.
Wear ANSI-approved safety impact
6.
goggles during use.
Use the Saw Blade Guard and
7.
Spreader for every operation for
which it can be used, including all
through sawing.
Keep hands out of the line of the Saw
8.
Blade.
Do not perform any operation free-
9.
hand.
Do not reach around or over Saw
10.
Blade.
Always use Saw Blades (not includ-
11.
ed) with a 10” diameter, 5/8” round
arbor hole, and rated at 3450 RPM
or greater.
Saw Blades that do not
match the mounting hardware of the
Table Saw or that are rated less than
the required minimum RPM will run
eccentrically causing loss of control
or may fly off the Saw.
Make sure the Table Saw is located
12.
on a flat, level, sturdy surface ca
-
pable of supporting the weight of the
Saw and workpieces.
Do not use the Table Saw for cutting
13.
metals or for cutting curves.
This will
cause the Saw Blade to break and/or
reduce its service life.
Make sure the Table of the Table Saw
14.
and surrounding area are clear with
the exception of the workpiece to be
cut.
Before using the Table Saw, check to
15.
make sure the Saw Blade is properly
mounted on the Saw Spindle. Make
sure the Saw Blade is balanced, and
is not cracked or bent.
Industrial applications must follow
16.
OSHA guidelines.
Never stand on the Table Saw. Seri-
17.
ous injury could result if the Table
Saw is tipped or if the rotating Saw
Blade is accidently contacted.
Never attempt to cut more than one
18.
workpiece at a time.
Never attempt to cut freehand. Make
19.
sure the workpiece to be cut is
pressed firmly against the Table.
When cutting a large workpiece,
20.
make sure its entire length is properly
supported. If necessary, use a roller
stand (not included).
Always feed the workpiece against
21.
the rotation of the Saw Blade.
Allow the Saw Blade to spin up to full
22.
speed before feeding it into a work-
piece. When turning off the Table
Saw, allow the Saw Blade to spin
down and stop on its own. Do not
press against the Saw Blade to stop
it.
To avoid accidental injury, always
23.
wear heavy duty work gloves when
changing the Saw Blade.
The Saw Blade will become hot while
24.
cutting. Allow the Saw Blade to com-
pletely cool before handling.
Do not force the workpiece into the
25.
Saw Blade when cutting. Apply
moderate pressure, allowing the Saw
Blade to cut without being forced.
