Central Machinery Industrial 97816, Set Up And Operating Instructions Manual

Page: 14 / 34

Page 14 SKU 97816 For technical questions, please call 1-800-444-3353.
FIgurE H
HANd WHEEL
(202)
HANd WHEEL
LOCK
(201)
HANdLE
ANgLE/HEIgHT
SHAFT
(218/245)
To Install the Saw Blade
CAuTION! 1.
To avoid accidental cuts,
make sure to wear heavy duty work
gloves when installing the Saw Blade
(not included).
Use one accessory Wrench to loosen
2.
(turning clockwise) the Nut (275)
while holding the Blade Arbor (278)
in place with the other Wrench.
(See Figure I.)
Remove the Nut (275) and the Arbor 3.
Flange (276) from the Blade Arbor
(278). (See Figure I.)
Install the Saw Blade onto the Blade 4.
Arbor (278). Make sure the Saw
Blade Teeth point toward the
front of the Table Saw, (the power
Switch is located on front of
table).
Slide on the Arbor Flange (276), 5.
and counterclockwise thread the
Nut (275) back onto the Blade Arbor
(278). (See Figure I.)
Use one accessory Spanner to firmly 6.
tighten (turning counterclockwise) the
Nut (275) while holding the Blade Ar-
bor (278) in place with the other Span-
ner. (See Figure I.)
FIgurE I
NuT
(275)
BLAdE ArBOr
(278)
ArBOr FLANgE
(276)
To Install the Table Insert
Select either the Standard Table Insert 1.
(131) or the Dado Table Insert (136) to
be installed.
(See Figure j, next page.)
Set the selected Table Insert (131 2.
or 136) into the opening in the Table
(126). (See Figure j, next page.)
Use a Hex Wrench to raise or lower 3.
each of the four Set Screws (132)
until the Table Insert (131 or 136) is
flush with the Table (126) top. Use a
straight edge to make sure the Table
Insert is flush with the top of the Table.
(See Figure j, next page.)
Check to make sure the Saw Blade 4.
will not come into contact with the
Table Insert (131 or 136). Position the
Saw Blade at 90°. Then, raise and