Page 19
SKU 97816
For technical questions, please call 1-800-444-3353.
Select a tooth on the far side of the
3.
Saw Blade and directly over the Table
Insert (131 or 136). Mark the tooth
with a marker. Measure the distance
from the side of the Saw Blade to the
right T-Slot edge in the Table (126) us-
ing a combination square. Make sure
to measure between the teeth, not on
the tooth.
(See Figure T.)
Rotate the Saw Blade toward the front
4.
so that the marked tooth is just above
the Table Insert (131 or 136). Mea-
sure the distance from the side of the
Saw Blade to the right T-Slot edge.
The two measurements should be the
same.
(See Figure T.)
5. If the measurements are not the
same, loosen the four Capscrews
(102) that hold the Table (126) to the
Cabinet (101). Adjust the Table until
the two measurements are the same.
Then, retighten the four Cap screws.
(See Figure u.)
FIgurE T
OpErATINg INSTruCTIONS
read the ENTIrE IMpOrTANT
SAFETY INFOrMATION section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
To use The rip Fence Assemby
WArNINg!
1.
When using the Rip
Fence (1 thru 17) assembly, always
keep hands and fingers well away
from the Saw Blade and cutting area.
Set the Rip Fence (1 thru 17) assem-
2.
bly on the right Extension Wing (127)
of the Table Saw.
(See Figure V, next page.)
Adjust the Rip Fence (1 thru 17) as-
3.
sembly to the desired width of cut
(distance from Saw Blade to Rip
Fence) by viewing on the scale indi-
cator located on the right hand side of
fence. Then, pull down on the Lock
FIgurE u
TABLE MOuNTINg HOLES
