Release Valve
Be aware of dynamic loading!
If you
drop an item onto the jack, it may create for
a brief instant, an excess load. The Jack is
designed for 600 Lbs. maximum load only;
do not exceed.
Step 9: Move the Transmission Jack from beneath your vehicle. Position the Transmission Jack
for convenience. You may perform needed maintenance of the differential while it is on
the Transmission Jack.
Figure 6--Lowering the Saddle
Differential Installation
Step 1: Position the Transmission Jack underneath your supported vehicle.
Step 2: Turn the RELEASE VALVE clockwise to close the BODY RELEASE VALVE.
Step 3: Raise the SADDLE A by stepping on the PEDAL PUMP PISTON.
Step 4: When the differential is in the proper position, reattach the differential to your vehicle.
Step 5: After the differential is safely attached to your vehicle, lower the SADDLE A by turning the
RELEASE VALVE counterclockwise.
Step 6: Inspect the vehicle to insure the differential has been properly installed.
Transmission Removal
Step 1: Roll the Transmission Jack underneath the transmission of your vehicle.
Step 2: Make sure the RELEASE VALVE (#31) is turned fully clockwise to close the BODY RE-
LEASE VALVE (#27).
#33610
Page 7
Warning: