Your transmission should now be in position to allow you to mount it to the engine and vehicle. If
the transmission is not in correct position, repeat Steps 3-5 as needed.
Step 6: After the transmission is safely attached to your vehicle, lower the SADDLE by turning the
RELEASE VALVE counterclockwise.
Step 7: Inspect the vehicle to insure the transmission has been properly installed.
MAINTENANCE
Bleeding the Transmission Jack
Should you experience little lifting ability with your Transmission Jack, follow the Steps below to
bleed the Transmission Jack. Make sure the Transmission Jack is not lifting anything while per-
forming Maintenance.
Step 1: Unscrew and remove the AIR VENT VALVE (#34) from the RESERVOIR (#18) as shown
in Figure 10.
Step 2: Raise the Jack’s RAM up to the full height.
Step 3: Turn the RELEASE VALVE (#31) counterclockwise to open the BODY RELEASE VALVE
(#27). Quickly press the RAM (#25) down into the RESERVOIR.
Step 4: Insert the AIR VENT VALVE back into the RESERVOIR. Tighten.
Your Transmission Jack has been bled.
Figure 10--Removing the Air Vent Valve
#33610
Page 10