Page 14
For technical questions, please call 1-888-866-5797.
Item 62120
Configure Monitors
Note:
Configuring the Monitors is
not required
to operate the Scan Tool
.
BEFORE CONFIGURING MONITORS:
• Run
“I/M Readiness Quick-Check” on
page 17
to determine which Monitors
are not supported on the vehicle.
• Refer to EPA guidelines for acceptable
incomplete monitor limits.
1. From
System Setup
, select
Configure Monitors
, then press
OK.
Configure Monitors 1/4
?
Spark IGN Required Mon.
Compression IGN Required Mon.
Allowed INC Monitors
Reset Factory Default
Figure G
2. Select a configuration, then press
OK.
a.
Spark IGN Required Mon.
For gasoline engines.
b.
Compression IGN Required Mon.
For diesel engines.
c.
Allowed INC Monitors
to
Set how many incomplete
Monitors are acceptable.
d.
Reset Factory Default
3.
Custom Data Set
screen shows
which buttons can be used to
configure the monitors. Press any
button to move to the next screen.
……………
Custom Data Set
……… …..
[
] – Select/Deselect
[ ] – Select/Deselect all
[OK] – Confirm
[ESC] – Cancel
Press any key to con.
Figure H
4. For
Spark IGN Required Mon.
and
Compression IGN Required Mon.,
deselect Monitors that are not supported
on the vehicle, see
“I/M Readiness
Quick-Check” on page 17.
…………
Spark IGN Monitors
1/10
FUEL
CCM
?
√
√
√
√
CAT
HCAT
EVAP
MIS
Figure I
5. For
Allowed INC (incomplete)
Monitors,
select the number of
incomplete Monitors allowed. Refer
to EPA guidelines for acceptable
incomplete monitor limits.
…………
Allowed INC Monitors
1/4
1
2
?
3
0
Figure J
