GB
Figure 5.1.2:
Inside of base hopper
5. Layout
The layout is presented on the basis of the SW 200
and differs from the type SW 300 only in the shape
of the hopper attachment.
a
Frame, complete
b
Drawbar, complete
c
Handle
d
Wheel, complete
e
Wheel shutoff, left
f
Wheel shutoff, right (covered)
g
Wheel bearing (both sides)
h
Axle with bearing (covered by axle boot)
Axle boot
Gearbox with aluminium housing, complete
Shaft coupling
Vertical axle for agitator (covered)
Spreader disc,
adjustable
Vertical axle
bearing
Pusher, complete
Spreader guard
Agitator
Basic hopper
Anti-compaction panel
Hopper attachment
Lighting, complete
17
19
6. Initial setup
6.1 Preparation
Remove the preassembled assemblies and all indi-
vidual parts from the packaging and lay them out
clearly on a level, clean floor.
Assembly tools:
• Spanner SW: 8, 10, 13, 19.
• Side cutter.
6.2 Assembly
6.2.1 Drawbar with drawbar eye /
ball head coupling (optional)
1. Loosely mount the drawbar to the frame and
handle with screws
A
.
2. Hang spreader onto towing vehicle by means of
drawbar eye (optional: ball head coupling).
3. Align the spreader horizontally by positioning
screw
C
in the holes in the handle.
4. Align the spreader horizontally by positioning
screw
D
in the holes in the drawbar eye.
5.Tighten all screwed connections.
A
A
Figure 6.2.1.1: Assembly of drawbar complete
Figure 6.2.1.2: Screw C
Figure 6.2.1.3: Screw D
C
D
22
5
4
13
6
7
2
3
16
15
Figure 5.1.1: Spreader SW 200
1
9
8
10 11 12
14
20
18
22
17
Summary of Contents for SW200
Page 35: ...F 35 ...
Page 36: ...36 D GB GB GB F ...
Page 38: ...Notizen 38 ...
Page 39: ...Notizen 39 ...
