22
6.6) Errors/Malfunctions
These appear on the display during operation, combined with a beep to notify the operator of
procedural or operational errors.
Message
Error description
S
olution
ERROR
Ï
Ð
In
CUTTING
mode:
The cutting phase has been intention-
ally interrupted by the operator.
The pump has not developped the
pressure needed to cut the cable
In
CRIMPING
mode:
Oil discharge is activated before wait-
ing for the motor to be automatically
switched off
.
In order to reset the alarm, press the pump
button on the radio control once for 2
seconds.
Repeat the cycle by holding the pump button
until the motor switches off automatically.
Repeat the crimping cycle, keeping the
pump button pressed down until the motor
switches off automatically.
The pump has been started without the
fl exible hose connected or the hose is
not correctly connected.
In order to reset the alarm press the release
button, connect the fl exible hose or check
the correct connection to the pump.
001
Ï
Ð
Abnormal power consumption of the
motor.
The pump stops.
Remove and re-insert the battery, then re-
start the pump.
If the error occurs frequently, contact
Cembre
.
002
Ï
Ð
Output voltage of the pressure trans-
mitter is out of the pre-set range.
The pump stops and doesn't re-start.
Remove and re-insert the battery, if the error
occurs, contact
Cembre
.
003
Ï
Ð
Failure to reach the set pressure within
120 seconds of continuous operation
of the pump.
Repeat the work cycle; if the error occurs
frequently, contact
Cembre
.
004
Ï
Ð
Overcharging of the battery with pro-
tection tripping.
The pump stops.
Remove and re-insert the battery, then re-
start the pump.
If the error occurs frequently, contact
Cembre
.
6.7) Return to original default settings / fi rmware version
Select screen 10 from the “main menu” (Ref. to
section 6.1
), to return the pump to its default set-
ting hold the finger on the button (9) until a confirmation “beep” is heard.
The RESET screen also shows the fi rmware version of the control board.
RESET
SW:S1J76202