20
6.3) Change the "release mode"
The method of discharging the oil into the pump’s tank can be carried out in two diff erent ways,
depending on the mode set in the menu:
Release mode
Associated pictogram
Function
SMART
default setting
By releasing the pump button the oil is returned in full to
the pump reservoir only following automatic shut-off of
the motor.
During the return phase, pressing the buttons allows the
head ram retraction to be interrupted at any point.
MANUAL
To return the oil to the pump reservoir it is necessary to
press and hold the release button.
During the return phase, by releasing the button it is pos-
sible for head ram retraction to be interrupted at any point.
To change the "release mode", proceed as follows:
- Select screen 4 from the “main menu” (Ref. to
section 6.1
), hold the finger on the touch button(9) until a
confirmation “beep” is heard, the choice made is show by the related pictogram.
When the battery is removed from the pump or after 1 hour of inactivity (display OFF),
once you wake the pump up, it will always start with the default setting, SMART mode.
6.3.1) Extended release phase
I
f necessary, the phase of discharging the oil into the pump’s tank can be extended, leaving the
release valve open for 60 seconds.
This function is useful in the event that the blades are jammed after the cutting operation. It allows
the operator to work on the cutting head using both hands in case of a blade jamming.
To activate "extended release" proceed as follows:
- Press quickly (3 times within 2 seconds) the release button on the radio con-
trol RRC1 or the button (11) backward on the pump if RC mode is disabled.
The operation is then reported on the display by a counter associated with an
intermittent buzzer.
- In order to stop the countdown before reaching zero, press the pump button
on the radio control once for 2 seconds.
58
01
59
60
.........
