19
(*) Screens 1-2-6-7-8-9 can be set as the “main screen” which is shown
on the display every time the pump is operated; to do this, when the
pre-selected screen is displayed, hold the fi nger on the touch button
(9) until a confi rmation “beep” is heard.
6.2) Choosing the "operating mode"
The “operating mode” allows the user to defi ne the pump function depending on the type of
hydraulic head connected. This enables the optimization of the job cycle and discharging of the
battery. It is possible to choose between two diff erent operating modes:
CUTTING (
default setting
)
CRIMPING
Operating mode
Associated pictogram
Function
CUTTING
default setting
Specifi cally for using the pump with
Cembre
hydraulic
heads for cutting electrical conductors where the absence
of voltage cannot be guaranteed.
CRIMPING
Specifi cally for using the pump with
Cembre
hydraulic
heads for crimping of electrical connectors.
NOTE:
When the crimping mode is active, the LED light
and the buzzer are deactivated.
To change the desired “operating mode”, proceed as follows:
- Select screen 3 from the “main menu” (Ref. to
section 6.1
), hold the finger on the touch button (9) until a
confirmation “beep” is heard, the selected operation mode is shown by filling the related pictogram.
When the battery is removed from the pump or after 1 hour of inactivity (display OFF),
once you wake the pump up, it will always start with the default setting, CUTTING
MODE.
BEEP
2
