Page 6 | 1-800-343-9463
CCM9000
101017
RECEIVING & INSPECTING THE SYSTEM
•
Use caution when lifting and check package for damage .
•
Lift only at the designated hand-hold locations on the shipping container, or fully support the container from
underneath . A shipment may include one or more boxes containing accessories .
•
Before opening the container, inspect the packaging for any obvious signs of damage or mishandling .
•
Write any discrepancy or visual damage on the bill of lading before signing .
•
Allow the condensing unit to sit for 24 hours prior to startup . The condensing unit can be placed in the
installation location, piped and evacuated during this time .
Note: CellarCool units are manufactured in the USA and tested prior to shipment .
•
Review the packing slip to verify contents .
•
Check the model number to ensure it is correct .
•
Check that all factory options ordered are listed .
If any items listed on the packing slip do not match your order information,
contact CellarCool Customer Service immediately.
Check all shipped boxes for the following contents:
Please leave the system in its original box until you are ready for installation . This will allow you to move the product safely
without damaging it . When you are ready to remove the product from the box, refer to the installation instructions .
TIP: Save your box and all packaging materials . They provide the only safe means of transporting/shipping the system .
Evaporator Unit Box 1
Condensing Unit Box
(1) Master evaporator unit
Evaporator installation hardware bag (master)
:
•
(12) 21/2” Phillips wood screws
•
(12) #8 3/8” Phillips pan-head screws
•
(1) Bypass plug
•
(1) 1/4” barbed coupling
•
(2) 3” strips of cork tape
Documentation bag (master)
:
•
CM9000 Twin owner’s manual
•
CM9000 Twin technician’s manual
•
R-404a split system warranty checklist
(1) CM9000 condensing unit
KDT Plus hardware bag
:
•
(1) 11/16” OD grommet
•
(2) 1/2” nylon hole plugs
•
(4) #6 x 1” Phillips zinc Type A screws
•
(4) 8-10 x 7/8” blue plastic screw anchors
Accessory kit bag (master)
:
•
Stainless steel probe (50 feet)
•
KDT Plus display cable (50 feet)
•
KDT Plus wall mount bracket assembly
•
KDT Plus flush mount bracket assembly
•
KDT Plus display assembly
•
Flush mount template
•
Evaporator installation hardware bag
•
KDT Plus hardware bag
Insulation blanket bag (master)
:
•
(1) CM9000 insulation blanket
Condensing unit accessory kit
:
•
(1) Filter drier
•
(1) Sight glass
Evaporator Unit Box 2
(1) Slave evaporator unit
Evaporator installation hardware bag (slave)
Insulation blanket bag (slave)
:
•
(1) CM9000 insulation blanket
Evaporator installation hardware bag (slave)
:
•
(12) 21/2” Phillips wood screws
•
(12) #8 3/8” Phillips pan-head screws
•
(1) Bypass plug
•
(1) 1/4” barbed coupling
•
(2) 3” strips of cork tape
