www .cellarcool .com | Page 19
CM9000 Twin-S
__ Min. Tack Time
Adhesive
__ Min. Cure Time
Directions
__ M
in. T
ack
Tim
e
Dire
ctio
ns
INSULATION BLANKET INSTALLATION
1 . Once mounting bracket location has been selected and installed, proceed to the insulation blanket installation .
2 . Spray adhesive onto the sides of the portions of each evaporator unit and mounting bracket which protrude into
the attic . See spray adhesive directions for proper tack time before proceeding to step 3 (see illustration) .
3 . Wrap insulation piece (A) around the sides of each evaporator unit . Make sure the bottom edge of the insulation is
flush with the top edge of the mounting bracket (see illustration) .
4 . Set insulation in place by pressing firmly on all surfaces of the insulation that come in contact with the sides of
each evaporator unit (see illustration) .
5 . Using a utility knife, cut holes in the insulation for the line set, wiring, and drain line if needed .
6 . If necessary, cut the insulation to size using the top edge of each evaporator unit as a template . Remove excess
insulation . Proceed to piece (B) installation .
*Tools required: spray adhesive, utility knife, cork tape, foil tape
If needed, trim excess insulation around all edges .
A
A
A
H
H
H
H
11.25”
14.25”
68”
Insulation Blanket
B
Insulation Blanket
B
Mini CM9000 blanket dimensions
CM9000 blanket dimensions
22”
102”
35.75”
14.25”
11”
Insulation Blanket
A
Insulation Blanket
A
A
