DTV-UDWG100F User Manual
Guilin CEKE Communication Equipment Co., Ltd.
Add: D-08, Information Industrial Park, Chao Yang Rd, High-tech District, Guilin, Guangxi, 541004, P.R.China.
Tel: +86 773 2120 156 Fax: +86 773 2120 299 Email
：
[email protected] Web: www.glsq.com
6
●
Installing clamp (for models
≥
1W) 2 sets
●
Optional accessories one set
If any parts are missing or damaged, please contact the supplier.
4-2
．
Safety Requirements
Before installing the equipment, the user should check whether the AC input voltage
range is within the equipment allowable range or not; check the ground connection is
intact or not. Please make sure the isolation degrees between the transmitting antenna
and RF input should be greater than the equipment nominal isolation degrees. Please
check all correct cables connections before the installation.
4-3
．
Rack Mounting
Outdoor repeater can be installed on the wall or on the pole. When the equipment is
installed in the wall, the user can use screws or expansion screws to fix instead of
clamps. As for rack installation, please pay special attention to the environment around,
the rack should be installed in the shade with good ventilation. There should be no
block material within the range of 50CM, under or above.
Please refer to diagram below to finish the installation.
Screw
Wall or flat objects
Interfaces
Repeater
Screw
Gin Pole
Interfaces
Repeater
Blocking
Hoop
Screw
Wall or flat objects
Interfaces
Screw
washer
Interfaces
Gin Pole
Blocking
Hoop
Repeater
Repeater
1
W above models 1W above models mw-level models mw-level models
Wall-mounting Hoop Install Wall-mounting Hoop Install
4-4
．
Accessories Installation
There will be built-in or external accessory module for different power/type of the
series equipment. All the built-in accessory modules are installed in the factory, users
