DTV-UDWG100F User Manual
Guilin CEKE Communication Equipment Co., Ltd.
Add: D-08, Information Industrial Park, Chao Yang Rd, High-tech District, Guilin, Guangxi, 541004, P.R.China.
Tel: +86 773 2120 156 Fax: +86 773 2120 299 Email
：
[email protected] Web: www.glsq.com
25
GPRS module is installed as shown in the picture below. Twist off the 4 screws around
the GPRS module and put the SIM card inside to fit the card slot. The orange indicator
light will turn on two minutes after being switching on. If the ACT indicator light
doesn’t show on, please check possible overdue GSM card bill, or the loose connection
between antenna and other cables. Or there might be weak signal and strong
disturbance, please check if the antenna and feeder of GPRS are in near distance with
output port and feeder of the repeater, which should be set far from repeater antenna. If
the GPRS doesn’t work after being se up by the steps above, or the signal is too weak
and interference is too strong, an extension cable with length of 10 meters should be
added to the output interface of GPRS module. Try to keep the GSM antenna away
from repeater transmitting antenna. Use waterproof tape to cover the connectors. If the
signal is normal, there is not need to add 10 meters extension cables, which will cause
attenuation to GSM signal.
If there is no GSM mobile signal nearby, GPRS function is not available.
It takes about 1 minute for the GPRS to get started. Please wait patiently. Please call
you mobile phone service provider to apply for GPRS service, 30M is enough.
GPRS setting at repeater end:
GPRS has been set in the factory, and there is not need to modify. If there is accidental
modification, you can set it up as below:
1. ID repeater ID card. First four numbers shown in repeater tag.
For example, repeater tag is NO. SQ12050014R010, then ID is 0014.
2
．
VERSION: 3.52 check the program version of repeater, can not be modified.
3
．
MODEL mode default00, no need to set up.
4
．
GPRS ENABLE
GPRS switch. Remote control comes into use only when the
GPRS enable.
5
．
SERVER IP Service IP address
. Set up IP address for remote control.
Default: 222.052.140.130, no need to modify.
