Radiance Technical Service Manual
Cecilware
®
7
Installation (continued)
Start-up
1. Turn on power switch located just behind front
panel near bottom to the “ON” position. Water will
flow into the tank and will stop when the tank is
full (5 - 15 minutes).
2. After water has stopped running into tank, open
door. No unlatching is required. Slowly lift door
upwards. Door has a counter-balance system that
will hold the door open to a position of
approximately 105 degrees from vertical.
3. Clean, sanitize, and reassemble Hopper and
Whipper assemblies before first use. See
Cleaning
.
Important: Parts must be completely dry before
installing.
IMPORTANT:
Check to make sure that the Auger and
Pinwheels inside the Hopper are correctly installed prior
to filling.
4. Rotate the Dispense Elbow to the “up” position.
Remove hoppers by lifting. Fill Hoppers with dry
powder product. The Hoppers hold up to 5 pounds
of Cappuccino product. Install Flavor Labels to
match product. (Place one on each Hopper.) Place
the Hopper back into position. Ensure front pin
drops into hole.
5. Turn Dispense Elbow down toward the mixing
funnel.
6. Close door by gently pulling down.
7. Models A and B: Change Dispense Button flavors to
match flavor in each hopper. See
Adjustments
section.
8. Model C: Apply matching Flavor Decals to area
above each dispense button.
Allow 100 minutes (125 minutes for Radiance 10) for
the water to reach operating temperature after tank
has filled.
•
Models A and B: The Dispense Button will change
from gray to brightly lit. The Dispense Buttons will
change from displaying “HEATING” to “DISPENSE”.
•
Model C: Dispense Buttons will start to pulsate.
•
The unit will not dispense product if water is not
heated to preset temperature.
•
Rinse each head to clear powder spillage when
filled hopper was installed. See
Cleaning
section.
Your Radiance Cappuccino dispenser is ready to
dispense!
WARNING:
Do not open door until water has
stopped flowing into hot water tank. Otherwise unit
may tip over, causing severe injury.
Power
Switch
Power
Switch
Radiance 5
Radiance 10
Pin drops
into hole