32
10 CG-Controller configuration created from
PC software
After a SD is inserted, the address 0x060 inconfigcg.dat is
tested. If the CG-Controller detects a new CG-Controller
configuration for the PC software, the place is 0x01.
If confirmed with yes, the new configuration will be accepted as
follows:
Line
Display:
1
New CG controller
2
Accept configuration of
3
SD
n/y
4
Operation:
Menu One menu level higher
/ Select yes/no
Confirm selection
10.1 Read new configcg.dat from SD automatically
Line
Display:
1
New configuration
2
Load ...
3
Read configcg.dat..
4
Please wait...
10.2 Find devices automatically
Line
Display:
1
2
Automatic search
3
4
Please wait...
10.3 Save Configcg.dat to SD
Line
Display:
1
New configuration
2
Save....
3
Save configcg.dat
4
Please wait...
At the end Byte EE_NewConfigCG at 0x060 is setted to 0xFF.
10.3.1 Network device configuration created from
PC software
First the system performs the steps described under «10 CG-
Controller configuration created from PC software». The PC
software sets the address 0x060 in configcg.dat on 0x01 if
devices have been deleted or added.
After that the device status of all network systems is tested. If
the device status of a system = 0x02, configxx.dat and
textexx.dat will automatically be downloaded to this system. All
systems marked with 0x02 on the SD will be updated. Finally the
CG-Controller sets 0x060 on 0xFF and the particular device
status on 0x01.
