38
J
Fig. 44b
Injectors replacement of
top burners
Every cooker is provided with a set of injec-
tors for the various types of gas.
Injectors not supplied can be obtained
from the After-Sales Service.
Select the injectors to be replaced accord-
ing to the table at page 39.
The nozzle diameters, expressed in hun-
dredths of a millimetre, are marked on the
body of each injector.
To replace the injectors proceed as follows:
–
Remove the grids and extract the burner
bodies.
–
Using a wrench, substitute the nozzle
injectors “
J
” (Figs. 44a - 44b) with those
most suitable for the kind of gas for
which it is to be used (see “Table for the
choice of the injectors”).
The burners are constructed in such a
way so as not to require the regula-
tion of the primary air.
Adjusting of the minimum
of the top burners
Considering that in the minimum position
the flame must have a length of about 4
mm and must remain lit even with a quick
turn from the maximum position to that of
minimum.
The flame adjustment is done in the follow-
ing way:
– Turn on the burner
– Turn the tap to the MINIMUM position
– Take off the knob
– With a small flat screwdriver turn the
screw inside the tap rod to the correct
regulation (fig. 45).
Normally for LPG, tighten up the regu-
lation screw.
Fig. 45
J
Fig. 44a
Conversion to Natural Gas or to LPG
