Connect LED light cable
Interface unit
In-Sight5000 series
Connecting wires
Connecting wires
5
5
4
4
How to mount
How to mount
7
Installation location
On a flat and stable location with minimal vibration.
Places free from corrosive or combustible gas.
Places that are not subject to sudden temperature changes.
Places where products can be grounded.
Mounting procedure
Compliance with IP67 protection
4
How
to
mount
5
Connecting
wires
8
Image Figure
Image Figure
LED light
Extension I/O module
(1450 or 1460 from Cognex)
Interface unit
In-Sight5000 series
Trunk cable (for light)
Mounting onto In-Sight5000 series
Typical mounting to fixed place
Terminal unit
such as a PC
External control equipment
such as a PLC
Be sure to mount this interface unit to
the In-Sight5000 series.
*
For cable connections, please refer to
information in Chapter 5 “Connecting wires”.
To make use of holes for mounting
in this interface unit:
Use M5 screws.
Need to make Ø6.0-7.0 holes through the
fixed place.
To fix to the fixed place with screws:
Use M4 screws.
Need to make M4 holes for mounting in the
fixed place.
M4 fixing screw provided (4 pieces)
Interface unit
In-Sight5000 series
Break out cable
Bre
ak o
ut c
able
Ethernet
Connecting to In-Sight5000 series
Eth
ern
et
Fixed place
M5 screw
M4 screw
M5 hole for mounting
M4 hole for mounting or Ø6.0-7.0
Please install products to locations with following conditions.
Incorrect installation location may cause product failure.
Caution
Before connection, check to be sure that the power supply is turned
OFF. Making connections with the power supply ON may result in
a fire or an electric shock.
Caution
Cable connections
About connecting to In-Sight5000 series
This product operates when connected to In-Sight5000 series. Please connect to In-Sight5000
series only.
*
