CBM CMP-10, Manual

Page: 18 / 23

18 CITIZEN CMP-10
Note! If the cable is connected after printer SWITCH ON the IrDA selection will still be
valid. If the serial interface is to be used switch the printer OFF, connect the RS cable
and then switch ON again.
Low battery detection
The level of the battery is monitored at POWER ON, prior to paper feed and before
printing.
Possible detected levels are:
“CUTION” and “FATAL”.
Monitoring the temperature of the printing head
This parameter is monitored by an 8 bit ADC. By controlling the pulse width the tem-
perature of the head is maintained with limits below 50° C. If, for some reason, the
temperature level exceeds 55°C the printer will automatically stop printing and the bicolour
LED will indicate “error”.
Self testing and internal settings
-Keep LINE FEED pressed down.
-Press ON/OFF down and keep it down.
-Release LINE FEED.
-Release ON/OFF.
Immediately after releasing the ON/OFF button the printer will print out a SELF TEST
report.
Replacing the paper roll
CAUTION! Be sure to use specified paper rolls!
After switching the printer ON press the Cover Open button - the cover will open the
paper roll compartment. Place the new paper roll as shown
on illustration and pull out
enough paper to
reach the control panel of
the printer.
Note! Make sure that the
paper is correctly placed.
If it is tilted in one or an-
other direction and does
not come out straignt
from under the cover open
it and replace the roll again.