Cayin SMP-WEB3, User Manual

Page: 32 / 155

24
SMP-WEB SERIES
USER MANUAL
2-4-2 Step2: Display Settings
Here you can configure the settings relevant to the display
device. According to the actual screen connected to the SMP
player, please configure its screen resolution and refresh rate.
On some SMP models, you can select the video signal output.
If you would like to cut off the VGA signal in specific time to let
the screen switch to standby mode (applicable to most today's
screens for power saving), you can configure the applied time
and days.
SMP-WEBDUO provides several display modes. For detailed
introduction of each configuration, please refer to section
7-4
Display Settings
.
SMP-WEB4
1. Choose an output method from the drop-down menu and
display configurations such as display orientation and
resolution. Those information will be shown below the drop-
down menu according to your selection. Please configure the
settings accordingly.
2. Tick "
Hide Cursor
" checkbox if you don’t want to see the
cursor on the screen.
If you choose DVI or VGA
output (not Auto), those
resolutions with * sign after
the number are supported
by display’s EDID (or DDC)
i n f o r m a t i o n . C h o o s i n g
those resolutions without *
sign is not suggested and
the system may not work
properly. If you cannot see
any * after the resolution
number, please check your
display maker or your VGA/
DVI cable for EDID signal
support.