Cattron-Theimeg i-Key, Operation & Maintenance Manual

Page: 67 / 90


01/2001, CATTRON - THEIMEG
TM
Section 5, Page 15
Address, Frequency Bank, and Frequency report only
, continued.
5. To find the present Frequency Bank value, press and release button #2. The controller will
emit one long beep to alert you, then will beep out the Frequency Bank setting count with
short beeps. The green LED will also flash with each beep/count. (‘0’ is represented by a
long beep with no LED flash). Look, listen, and count to determine the existing value. Repeat
as necessary by pressing button #2. See Table 5-1 above to convert number of ‘Beeps’ to
‘Frequency Bank’ setting.
6. To find the present Frequency value press and release button #3. The controller will emit one
long beep to alert you, then will beep out the Frequency setting count with short beeps. The
green LED will also flash with each beep/count. (‘0’ is represented by a long beep with no
LED flash). Look, listen, and count to determine the existing value. Repeat as necessary by
pressing button #3. See Table 5-1 above to convert number of ‘Beeps’ to ‘Frequency’
setting.
7. Set the ON/OFF switch on the PS EZ or CS controller to ‘OFF’, then set the switch to ‘ON’
again for normal operation. While in normal operating mode all buttons perform as labeled -
frequency and address will not change.
END OF SECTION