Cattron-Theimeg i-Key, Operation & Maintenance Manual

Page: 60 / 90

Section 5, Page 8

01/2001, CATTRON - THEIMEG
TM
Address digit #1 entry and report (CS controller only
), continued.
5. To increment the Address Digit #1, press and release button #1. Each depression will
increment the Address Digit #1 by one, continuing from its present value until it reaches F,
then will roll over to zero and start again (the unit will beep each time button #1 is
depressed).
NOTE: On CS Controller, address codes 0000 and FFFF are not valid.
6. Press button #4 to confirm your desired setting.
7. Once you have entered the desired Address Digit #1, set the ON/OFF switch on the PS CS
controller to ‘OFF’ to permanently store the Address Digit #1.
Address digit #2 entry and report (CS controller only).
1. Referring to Figure 5-1 above, set the ON/OFF switch on the PS CS controller to ‘OFF’.
Make sure the red STOP Switch on the controller is unlatched and set to the ‘RUN’ (pulled
up) position.
NOTE: Provided a Frequency and Address has been programmed in the controller,
applying power to the controller with the red STOP Switch set to ‘STOP’
(pushed down) will immediately place the Controller in a STOP message
transmit cycle. If a Frequency and Address has not been pre-programmed in the
controller, the STOP message transmit cycle cannot be sent. Instead, the
controller will emit three long beeps and reset.
2. Press and hold down buttons #1 and #2 (see Figure 5-1 above) and set ON/OFF switch to
‘ON’. Pause approximately for one second or until the green LED illuminates, then release
buttons #1 and #2. The controller will emit one long ‘beep’, which means you are now in the
Main Menu of the address and frequency program.
NOTE: The yellow LED will flash instead of the green LED when low battery voltage is
detected.
3. Press and release button #1. The controller will emit one long ‘beep’ followed by one short
‘beep’ and the green LED will flash with the short ‘beep’. This indicates you are now in the
Address Data Entry and Report Mode.
4. To select Digit #2 Data Entry Mode, press and release button #2. To find the present
Address Digit #2 value, press and release button #4. The unit will emit one long beep to alert
you, then will beep out the Address Digit #2 setting count with short beeps. (i.e., eleven short
beeps if the Digit is ‘B’). The green LED will also flash with each short beep/count. (‘0’ is
represented by a long beep with no LED flash). Look, listen, and count to determine the
existing value. Repeat as necessary by pressing button #4. See above Address Table to
convert number of ‘Beeps’ to ‘Address Digit’ setting.