Cattron-Theimeg i-Key, Operation & Maintenance Manual

Page: 58 / 90

Section 5, Page 6

01/2001, CATTRON - THEIMEG
TM
Address digit #1 entry and report (CS controller only).
NOTE: The following Address Digit #1 and # 2 entry and reporting procedures are
not applicable to PSEZ Controllers. When programming a PSEZ Controller,
go directly to Address digit #3 entry and report
and Address digit #4 entry
and report on pages 9 and 10 of this section.
Figure 5-1. PSEZ & CS Remote Controllers, keypad-programming layout
1. Referring to Figure 5-1 above, set the ON/OFF switch on the PS CS controller to ‘OFF’.
Make sure the red STOP Switch on the controller is unlatched and set to the ‘RUN’ (pulled
up) position.
NOTE: Provided a Frequency and Address has been programmed in the controller,
applying power to the controller with the red STOP Switch set to ‘STOP’
(pushed down) will immediately place the Controller in a STOP message
transmit cycle. If a Frequency and Address has not been pre-programmed in the
controller, the STOP message transmit cycle cannot be sent. Instead, the
controller will emit three long beeps and reset.
Red STOP Switch
STOP
‘ON/OFF’ Switch
Color Coded i-Key
BUTTON #1
BUTTON #2
BUTTON #4
BUTTON #3
Button #1 and #2
are not used for
address digit select
or reports on EZ Z
controllers
NOTE: