Cateye stealth 50 cyclocomputer CC-GL50, Instruction Manual

Page: 37 / 41

37
Introduction
How to install the
unit on your bicycle
Setting up the
computer
How to use the
computer
Setup of your PC
Uploading the
measurement data
Changing the
computer
configuration
Others
Trouble Check Items Remedy
MEM FULL flashes. Does the maximum re-
cording time or the num-
ber of trips exceed the
upper limit?
* For details, see “Record
interval and capacity
limit” (page 23)
Connect the computer to your PC
to upload the trip data (page 20).
All the trip data transferred to your
PC will be deleted from the com-
puter, and new data will be able to
be recorded.
Does the maximum time
for one trip exceed the up-
per limit?
* For details, see “Record
interval and capacity
limit” (page 23)
Perform the resetting operation
(page 16) to stop the current trip.
Then, you can record as another
trip.
The backlight does not
light up even at the
preset hour. Are the start time and end
time set to the same hour?
The backlight does not light up
when the start time and end time
are set to the same hour.
For information on how to set the
start/end time, see “Changing the
computer configuration” (page 27).
Is the start time of the
night-time set correctly?
For information on how to set the
start time, see “Changing the com-
puter configuration” (page 27).
The backlight lights up
during the daytime.
Troubles related to the ANT+ sensor
Refer to the following information when the optional or commercial ANT+ sensor is used.
* Pairing with the computer is required in order to use the ANT+ sensor. For details, see
“Pairing the sensor” (page 32).
* When a commercial ANT+ sensor is used, also refer to the instruction manual supplied
with your sensor.
Trouble Check Items Remedy
The heart rate can-
not be measured (
H
does not flash).
Did you perform pairing
with the heart rate sensor?
Perform pairing (page 32).
Is the electrode pad de-
tached from your body?
Wear the electrode pad appropri-
ately so that it is in close contact
with the body.
Is your skin dry? Moisten the electrode pad a little.
Is the electrode pad overly
worn and damaged after
long use?
Replace with a new one.
Is the battery for the heart
rate sensor used up?
Replace with new batteries.
The heart rate mea-
surement is not con-
stant (measurement is
performd at times, or
reset to 0). Is the heart rate sensor
attached correctly?
Attach the heart rate sensor in the
correct position by referring to the
relevant instruction manual.
The power cannot be
measured (
P does
not flash).
Did you perform pairing
with the power sensor
used?
Perform pairing (page 32).
Is the condition for
mounting the power sen-
sor cleared?
Mount the power sensor correctly
by referring to the relevant instruc-
tion manual.
Is the battery for the
power sensor used up?
Replace with new batteries.