6
How to install the
Click the button, then a browser will open and a
video will be played back.
Attach the bracket to the stem or handlebar
The FlexTight™ bracket can be attached to either the stem or the handlebar, depending on
how the bracket fits into the bracket band.
Caution:
Be sure to tighten the dial of the FlexTight™ bracket by hand. Tightening
it strongly using a tool, etc. may damage the screw thread.
When attaching the FlexTight™ bracket to the stem
How to install the unit on your bicycle
When attaching the FlexTight™ bracket to the handlebar
* To receive GPS signal effectively, adjust the direction of the bracket so that the computer
display faces to the sky.
Cut the excess length of the band using scissors.
Caution:
Round off the cut edge of the bracket strap to prevent
injury.
* To mount the bracket to an aero-shaped handlebar or larger stem, use the optional nylon
ties bracket.
Remove/Install the computer
Caution:
When removing, hold the unit to prevent it from falling.
When you have the ANT+ sensor
Mount the sensor according to the instruction manual of each sensor.
* For information on how to install the optional speed/cadence sensor (ISC-11), see “How to
install the speed/cadence sensor (ISC-11)” (page 39).
* For information on how to wear the optional heart rate sensor (HR-11), see “How to install
the heart rate sensor (HR-11)” (page 40).
Bracket band
Bracket band
Stem
Click
Handlebar
Dial
Dial
Bracket rubber pad
Bracket rubber pad
Bracket
Bracket
